Effect of light-curing time on microhardness of a restorative bulk-fill resin composite to lute CAD-CAM resin composite endocrowns.

PURPOSE: To evaluate the minimal irradiation time to reach a sufficient polymerization of a photopolymerizable restorative bulk-fill resin composite to lute endocrowns. METHODS: A photopolymerizable restorative bulk-fill resin composite (Filtek One Bulk Fill) was submitted to direct light-curing by a high power LED light-curing unit for 20 seconds as the positive control group (n = 10). Five more test groups (n= 10) were light-cured in a natural tooth mold from three sites (buccal, palatal and occlusal) under a 9.5 mm thick nanohybrid resin composite CAD-CAM endocrown (Lava Ultimate A2 LT), for different irradiation times: 90 seconds per site, 40 seconds per site, 30 seconds per site, 20 seconds per site and 10 seconds per site. Vickers microhardness measurements were made at two different depths and test/control ratios were calculated. Ratios of 0.8 were considered as an adequate level of curing. RESULTS: Analysis shows that 30 seconds x 3 was the minimal irradiation time that presented a test/control ratio above 0.8. Quantile regressions showed that the required irradiation time to reach a test/control ratio of 0.8 at a confidence level of 95% was 38 seconds and 37 seconds for 200 microm and 500 microm, respectively. There was no statistically significant difference between microhardness of the two depths except for the irradiation time of 10 seconds. A 120-second (40 seconds per buccal, palatal and occlusal site) light-curing of photopolymerizable bulk-fill resin composite to lute a resin composite CAD-CAM endocrown restoration can be considered sufficient to reach adequate polymerization.