In vitro analysis of prosthetic abutment and angulable frictional implant interface adaptation: Mechanical and microbiological study.

The aim of this study was to evaluate, in vitro, the microbiological sealing at the implant and different angles frictional prosthetic abutment interface, submitted or not to mechanical cycling, as well as the deactivation force and evaluation of the implant-abutment interface by scanning electron microscopy. For this study, the sealing capacity of eighty sets of abutments/implants of each angle, with and without mechanical cycling, with internal conical connection (locking tapper) (4.3 mm x 9.0 mm) constituted in Titanium alloy (Ti6Al4V), and stainless steel angled prosthetic abutment was evaluated (18Cr14Ni2.5Mo) according to ASTM F138-13a (Arcsys, FGM, Joinville, Brazil), 6 mm high and 4.2 mm in diameter at the coronary portion, and 3.5 mm high transmucosal, in 4 different angles (0, 5, 10 and 20 degrees ). After in vitro tests, 100% biological sealing was observed at the implant / prosthetic abutment interface within cycled and non-cycled conditions, for the straight, 5, 10 and 20 degrees inclination groups. There was no statistically significant difference in the removal force of the prosthetic abutments at different angles, under non-cycled conditions; however, under mechanical loading, the deactivation force was significantly higher for straight prosthetic abutments than with 10 and 20 degrees of angulation. Surface analysis revealed good adaptation between implants and abutments, and the presence of wear areas, independently of mechanical loading. It is concluded that the analysis of implant and prosthetic abutment interface revealed good adaptation between the parts, for all analyzed samples.